Young’s modulus or elastic modulus is a mechanical property of linear elastic solid materials. It defines the relationship between stress and strain in a solid material, and is given by:

$$ \sigma = E \varepsilon $$

where,

\(E\) is Young’s modulus of the material,

\(\sigma\) is the stress, and

\(\varepsilon\) is the strain.

Young’s modulus has units of pressure or stress (\(Pa, psi \)) since the strain is a dimensionless quantity. From the given relation, it can be seen that the elastic modulus is the ratio between stress and strain:

$$ E = \frac{ \sigma }{ \varepsilon } $$

Physically speaking, it is a measure of how rigid a material is. As the overall rigidity of a part is also dependent on the geometrical shape, it is necessary to have a shape-independent property to measure the material.

Young’s Modulus in Linear Elastic Materials

A solid material is called elastic if it is able to naturally return to its original shape after the applied loads are removed. On the other hand, if the ratio between stress and strain is constant during the deformation process, then Young’s modulus is also a constant, and the material is considered to be linear elastic.

Workbench Setup for Linear Elastic Materials

When setting up a structural simulation, Young’s modulus parameter for a linear elastic material must be specified as follows:

Learn more about linear elastic materials in the following document:

Young’s Modulus in Nonlinear Materials

In general, all solid materials are not linear elastic, especially when they are subjected to high levels of deformation. Figure 2 shows an example stress-strain curve for a ductile carbon steel material, as obtained from a uniaxial tension test:

It can be seen that the material has a linear elastic behavior only for small strain values. When deformation increases, nonlinear behavior starts to occur. In this case, the ductile material exhibits plasticity, but other nonlinearities such as hyperelasticity or fragile rupture can also occur.

In general, most materials can be approximated to be linear elastic under the assumption of small deformation. In that case, the elastic modulus can be approximated by analyzing the linear portion of the stress-strain curve, and computing:

$$ E_y = \frac{ \sigma_y }{ \epsilon_y } $$

where,

\( E_y \) is the linear elastic Young’s modulus approximation,

\( \sigma_y \) is the stress value at the elastic limit (end of the straight line), and

\( \varepsilon_y \) is the strain value at the elastic limit.

Workbench Setup for Elasto-Plastic Materials

When setting up a structural simulation, Young’s modulus parameter for an elasto-plastic material must be specified as follows:

Learn more about elasto-plastic materials in the following document:

Linear Elastic vs. Elasto-plastic

In conclusion we can say for:

Linear elastic: The modulus determines the proportional relation between stress and strain, as described above.

Elasto-plastic: The modulus determines the linear portion of the deformation curve, where the stress-strain state is below the yield point. After the material crosses this threshold, the plastic deformation takes control.

Last updated: September 27th, 2021

Did this article solve your issue?

How can we do better?

We appreciate and value your feedback.

Contents

Cookie Policy

SimScale uses cookies to improve your user experience. By using this website you consent to our cookie policy.

This website uses cookies so that we can provide you with the best user experience possible. Cookie information is stored in your browser and performs functions such as recognising you when you return to our website and helping our team to understand which sections of the website you find most interesting and useful.

Strictly Necessary Cookies

Strictly Necessary Cookie should be enabled at all times so that we can save your preferences for cookie settings.

If you disable this cookie, we will not be able to save your preferences. This means that every time you visit this website you will need to enable or disable cookies again.